Tips

Home / FAQ

Keep your essential home appliances running efficiently and reliably 365 days a year. Follow these tips, and when you need a repair or complex maintenance, call 365Fixers!

Clean or replace the air filter regularly. Dirty filters reduce airflow, strain the compressor, and cause the unit to use more electricity. For a deeper clean, book a chemical wash once a year.

Leave the door ajar after each wash to let the drum air out. Wipe the rubber door seal and run a drum clean cycle monthly to prevent mould buildup and keep clothes smelling fresh.

Soak grease filters in hot water with dish soap monthly. Clogged filters reduce suction and are a fire hazard, especially with heavy cooking like stir-fries and curries.

Vacuum the condenser coils at the back or bottom vent every 6 months. Dusty coils make the compressor work harder and increase electricity usage.

Test the pressure relief valve on your storage water heater once a year. If it drips constantly or the water looks discoloured, call us – it may be time for a servicing or replacement.

If the power points keep have trips on the same buttom, this mean something is wrong with the wiring.

Use the correct voltage of 230V and 50H

A warm, discoloured, or burnt-smelling power socket is a warning sign. Stop using it and get it inspected – loose wiring or overloading can cause a fire.

Avoid daisy-chaining extension cords or plugging high-wattage appliances (aircon, water heater, washer) into a single multi-plug. Each heavy appliance should have its own dedicated socket.

Occasional flickering may just be a loose bulb. But if lights flicker in multiple rooms or when appliances switch on, it could point to a wiring issue or overloaded circuit – get it checked.

Check the air filter first – a clogged filter is the most common cause of weak cooling. Also make sure the temperature is set correctly and all doors/windows are closed. Still warm? Call us.

Water dripping from the indoor unit usually means a blocked drainpipe. Don’t ignore it – it can damage ceilings and walls. A chemical wash will clear the blockage.

Check the drain hose for kinks and clean the pump filter (usually behind a small panel at the front base). If water still won’t drain, there may be a pump fault – book a repair.

Check that the door seal is intact and the fridge isn’t overpacked (air needs to circulate). If the compressor runs constantly or the fridge is warm despite correct settings, call us.
Unplug all appliances on that circuit and reset the breaker. Plug them back one by one to find the faulty device. If it trips with nothing plugged in, there’s a wiring fault – call us immediately.

Every degree you lower the temperature adds roughly 10% more to electricity consumption. Set it at 25°C and use the fan mode or timer at night – you’ll barely notice the difference, but your bill will.

Appliances on standby still draw power. Switch off at the wall – especially the TV, water heater, and washing machine – when not in use. Small habit, noticeable savings over time.

Washing machines use roughly the same energy whether half-full or full. Wait for a full load before running a cycle to reduce the number of washes per week.

When replacing an appliance, look for 4–5 tick NEA Energy Label ratings. Higher-rated models cost more upfront but save significantly on electricity over their lifespan.

E1 – Indoor/outdoor communication fault. Try a full power reset. E2 – Anti-freeze protection triggered; check if the filter is blocked. F1 – Indoor sensor fault; requires a technician.

UE – Unbalanced load; redistribute clothes and retry. dE – Door not properly closed; check the latch. E3 – Drain error; check the drain hose and pump filter.

Er dH – Defrost heater fault. Er FF – Freezer fan motor issue. Er IS – Ice maker sensor fault. All three require a technician – don’t attempt to repair yourself.

If a power reset clears the error and it doesn’t come back – you’re fine. If the same error keeps recurring, or involves sensors, motors, or compressors, it needs a proper diagnosis. WhatsApp us the error code and we’ll advise.